AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
Make sure that the customize settings are set to default when performing the automatic light control system operation check.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS
Turn the ignition switch to ON.
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor.
Check that the taillights and low beam headlights come on.
Uncover the automatic light control sensor.
Check that the low beam headlights and taillights turn off.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK
Make sure that the customize settings are set to default when performing the light auto turn-off system operation check.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS
When the taillights are on (low beam headlights are not on)
Close all of the doors.
Turn the ignition switch to ON.
Turn the taillights on.
Turn the ignition switch off.
Open the driver door.
Check that all of the lights turn off immediately.
When the low beam headlights are on
Close all of the doors.
Turn the ignition switch to ON.
Turn the low beam headlights on.
Turn the ignition switch off.
Open any of the doors.
Close the door.
Check that all of the lights turn off after 30 seconds (delay function).
Before the lights turn off, if the lock button on the key is pushed after all of the doors are locked, all of the lights will turn off immediately.
DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK
Make sure that the customize settings are set to default when performing the daytime running light system operation check.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS
Turn the ignition switch to ON.
Turn the light control switch to the AUTO position (with the low beam headlights not turned on via the automatic light control system).
Release the parking brake.
Check that the daytime running lights come on.
WELCOME LIGHT ILLUMINATION CONTROL OPERATION CHECK
This check is possible only when the "Light up Clearance Lights at Door Unlock Function" customize setting is set to "ON" on the GTS. (The default setting is "ON".)
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS
Check that welcome light illumination turns on.
Turn the ignition switch off.
Set the light control switch to the HEAD position and then to the AUTO position.
Cover the automatic light control sensor.
Close and lock all doors.
Unlock all doors by wireless door unlock or entry door unlock.
Check that the taillights, clearance lights and license plate lights come on for 15 seconds.
Check that welcome light illumination turns off.
After the light is illuminated, the clearance lights are turned off when either of the following conditions is met before 15 seconds have elapsed.
The ignition switch is to ON.
The light control switch is in any position except the AUTO position.
Door lock is performed.
MANUAL HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK
Turn the ignition switch to ON.
Turn the headlights on.
Turn the headlight leveling switch to "0".
Check that the headlight beam level changes when the headlight leveling switch is operated.