| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|---|
| C13B516 | Electric Parking Brake Actuator Supply Voltage Circuit Voltage Below Threshold | ·
Diagnosis Condition: Ignition switch to ON or electric parking brake switch assembly pulled to lock side with ignition switch off. ·
Malfunction Status: Voltage at terminal +BS is less than 5.4 V* ·
Detection Time: Approximately 0.5 seconds
|
·
Wire harness and connector ·
Skid control ECU (brake actuator assembly) |
DTC stored | Brake/EPB | A | An electric parking brake system malfunction is displayed on the multi-information display. |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | Ignition switch to ON | ○ | - |
| Electric parking brake switch assembly pulled to lock side with ignition switch off | - | ○ | |
| Malfunction Status | Voltage at terminal +BS is less than 5.4 V*
|
○ | ○ |
| Detection Time | Approximately 0.5 seconds | Approximately 0.5 seconds | |
| Number of Trips | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
Inspect the fuses for circuits related to this system before performing the following procedure.
The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.
Pre-procedure1
Disconnect the A94 skid control ECU (brake actuator assembly) connector.
Procedure1
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A94)Location & Routingewd_type=routing;type=c;code=A94 Click Connector(A94)Engine Compartment>Engine Room Main Wire>Brake Actuator Assemblyewd_type=component;type=c;code=A94;pinno=14 |
||
| A94-14 (+BS) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG