Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for Toyota Connected Services)>PRECAUTION
When replacing the telematics transceiver, make sure to replace it with a new one.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Disconnect the H85 telematics transceiver connector.
Disconnect the V7 map light assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H85,V7)Location & Routingewd_type=routing;type=c,c;code=H85,V7 Click Connector(H85)Instrument Panel>Instrument Panel Wire / Speaker Wire>Telematics Transceiverewd_type=component;type=c;code=H85;pinno=3 Click Connector(V7)Body>No. 1 Roof Wire>Map Light Assemblyewd_type=component;type=c;code=V7;pinno=5 |
||
| H85-3 (SIG-) - V7-5 (GND3) | Always | Below 1 Ω |
| H85-3 (SIG-) or V7-5 (GND3) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(V7)Location & Routingewd_type=routing;type=c;code=V7 Click Connector(V7)Body>No. 1 Roof Wire>Map Light Assemblyewd_type=component;type=c;code=V7;pinno=8 |
||
| V7-8 (RRID) - Body Ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Remove the map light assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Apply auxiliary battery voltage to the connector.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → V7-8 (RRID)
Auxiliary battery negative (-) → V7-5 (GND3) |
Always | Manual (SOS) switch illumination comes on |
Check if the manual (SOS) switch illumination comes on.
The manual (SOS) switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT