| ● | Non-reusable part | ★ | Precoated part |
68984
1.INSTALL BACK DOOR STAY STOPPER
Engage the claw and install the back door stay stopper to the back door lower damper stay bracket.
68948
2.INSTALL BACK DOOR LOWER DAMPER STAY BRACKET
Clean the 2 bolt holes on the vehicle body.
Apply adhesive to the threads of the 2 bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the back door damper stay lower bracket with the 2 bolts.
68946
3.INSTALL BACK DOOR UPPER DAMPER STAY BRACKET
Install the 2 bushes.
Install the back door damper stay upper bracket with the 2 new bolts.
68960B
4.INSTALL BACK DOOR STAY ASSEMBLY
Do not perform work if the back door is not securely supported.
The back door could fall, resulting in injury.
Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.
Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.
Engage the 2 ball joints to install the back door stay assembly.
Install the back door stay assembly while supporting the back door by hand.
Check that the ball joints are engaged securely and the back door stay assembly cannot be pulled off.