Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.08–2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0446873 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C141C49  Brake Booster Motor "A" Control Internal Electronic Failure  C141F7F  Brake Booster Motor "A" Control Actuator Stuck Off  


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) detects a drop in accumulator pressure according to the signals from the accumulator pressure sensor, then operates and stops the motor relay as well as the pump motor.

The skid control ECU (brake booster with master cylinder assembly) troubleshoots the built-in motor relay drive circuit, and stores this DTC when a malfunction is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C141C49 Brake Booster Motor "A" Control Internal Electronic Failure After hard pump motor operation, when the accumulator pressure is less than 15.3 MPa (156 kgf/cm2, 2219 psi), the pump motor does not operate for 1 second or more. Skid control ECU (brake booster with master cylinder assembly) Brake/EPB A
C141F7F Brake Booster Motor "A" Control Actuator Stuck Off When a motor relay drive test is being performed, one or both motor relays do not operate for 0.2 seconds or more. Skid control ECU (brake booster with master cylinder assembly) Brake/EPB A

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
HINT:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model)>REMOVAL


Result:
Proceed to
NEXT



NEXT

END