Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.08–2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0446873 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C006396  Yaw Rate Sensor Component Internal Failure  C05201C  Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range  C05202A  Multi-axis Acceleration Sensor Module "A" Signal Stuck In Range  C052096  Multi-axis Acceleration Sensor Module "A" Component Internal Failure  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.

HINT:

When a malfunction occurs in the communication line to the yaw rate and acceleration sensor (airbag sensor assembly), U012587 is output.

If a DTC related to the CAN communication line is output, first troubleshoot the CAN communication line.


A DTC may be stored if either of the following is detected:

·

Incorrect installation of acceleration sensor (airbag sensor assembly).

·

Abnormal acceleration sensor (airbag sensor assembly) signal.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C006396 Yaw Rate Sensor Component Internal Failure Yaw rate sensor internal malfunction signal is detected. Yaw rate sensor (airbag sensor assembly) Brake/EPB A
C05201C Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range When the vehicle speed is 30 km/h (19 mph) or more, the difference between the deceleration value from the acceleration sensor and deceleration value calculated from the change in vehicle speed exceeds 0.35 G for 60 seconds or more.
·

Acceleration sensor (airbag sensor assembly) installed improperly

·

Acceleration sensor (airbag sensor assembly)


Brake/EPB A
C05202A Multi-axis Acceleration Sensor Module "A" Signal Stuck In Range When the vehicle speed is 10 km/h (6 mph) or more, the acceleration sensor output value does not change for 30 seconds or more.
·

Acceleration sensor (airbag sensor assembly) installed improperly

·

Acceleration sensor (airbag sensor assembly)


Brake/EPB A
C052096 Multi-axis Acceleration Sensor Module "A" Component Internal Failure Any of the following is detected:
·

The acceleration sensor output value does not change 16 times or more before the vehicle speed reaches 0 km/h (0 mph) from 30 km/h (19 mph).

·

The longitudinal and lateral output values of the acceleration sensor are not within the specified range for 60 seconds or more.

·

The lateral output value of the acceleration sensor is not within the specified range for 60 seconds or more.


·

Acceleration sensor (airbag sensor assembly) installed improperly

·

Acceleration sensor (airbag sensor assembly)


Brake/EPB A

CAUTION / NOTICE / HINT

If the yaw rate and acceleration sensor (airbag sensor assembly) was replaced or reinstalled, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY

PROCEDURE

1.REPLACE AIR BAG SENSOR ASSEMBLY

NEXT

END