If the ECM cannot recognize the millimeter wave radar sensor assembly. DTC U040181 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U040181 | Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received | Approximately 17 seconds or more after the ignition switch is turned to ON, the ECM cannot recognize the millimeter wave radar sensor assembly for approximately 5 seconds or more. | ECM | Radar Cruise2 | A |
Before replacing the ECM, refer to Service Bulletin.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| U040181 is not output | A |
| U040181 is output | B |
Post-procedure1
None.
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B