1.INSPECT CLUTCH PEDAL HEIGHT
Remove the front door scuff plate LH.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
Remove the cowl side trim board LH.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
Turn back the front floor carpet assembly.
Turn back the dash panel insulator assembly.
Check that the clutch pedal height is correct.
| *a | Clutch Pedal Height | - | - |
|
Measuring Plane of Floor Panel | - | - |
| Specified Condition |
|---|
| 154.6 to 174.6 mm |
| 6.09 to 6.87 in. |
If the result is not as specified, bleed the clutch line and perform the inspection again.
If the result is not as specified after bleeding the clutch line, replace the clutch master cylinder assembly.
Install the dash panel insulator assembly.
Install the front floor carpet assembly.
Install the cowl side trim board LH.
Install the front door scuff plate LH.
2.INSPECT CLUTCH PEDAL FREE PLAY
| *a | Clutch Pedal Free Play |
Check that the clutch pedal free play is correct.
Pay close attention to the change in resistance to distinguish clutch pedal free play while performing the inspection.
Depress the clutch pedal until clutch resistance begins to be felt.
| Specified Condition |
|---|
| 3 to 15 mm |
| 0.118 to 0.591 in. |
If the result is not as specified, bleed the clutch line and perform the inspection again.
If the result is not as specified after bleeding the clutch line, replace the clutch master cylinder assembly.
3.INSPECT CLUTCH RELEASE POINT
When checking the clutch release point, ensure that the vehicle is secure.
| *a | Release Point |
| *b | Full Stroke End Position |
| *c | Release Point to Full Stroke End Position |
| *d | Clutch Pedal Stroke |
Check the clutch release point.
Be sure to apply the parking brake and secure the wheels using wheel chocks.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever to reverse until the gears contact.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
| Specified Condition |
|---|
| 25 mm |
| 0.984 in. |
| Specified Condition |
|---|
| 141 to 151 mm |
| 5.55 to 5.94 in. |
If the result is not as specified, perform the following procedure.
Check the clutch pedal height.
Check the clutch pedal free play.
Bleed the clutch line.
Check the clutch cover assembly and the clutch disc assembly.