| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 2 | BACK-UP LIGHT SWITCH ASSEMBLY | 84210 | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the back-up light switch assembly removal/installation are shown below.
1.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
w/ Stop and Start System:
Click hereEngine / Hybrid System>M15A-FKS (STARTING)>STARTER (w/ Stop And Start System)>REMOVAL
w/o Stop and Start System:
Click hereEngine / Hybrid System>M15A-FKS (STARTING)>STARTER (w/o Stop And Start System)>REMOVAL
84210
2.REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
Disconnect the back-up light switch assembly connector.
Using a 27 mm deep socket wrench, remove the back-up light switch assembly and gasket from the manual transaxle assembly.