Home › Drivetrain › CLUTCH › CLUTCH SYSTEM › from 2021.07
RM3700E _52 Drivetrain _104786 CLUTCH _0480448 CLUTCH SYSTEM N

CLUTCH  CLUTCH SYSTEM  BLEEDING  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during bleed clutch line are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Air intake system parts Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

·

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.



PROCEDURE

Hide 55783E 1.REMOVE CENTER COWL TOP VENTILATOR LOUVER

Hide 47230 2.REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

Hide 3.FILL RESERVOIR WITH BRAKE FLUID

Hide 4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 5.BLEED CLUTCH LINE

a.
C459806C01
1.229,0.771 1.406,0.771 1.406,0.771 1.688,1.083 true 1.25,1.542 1.417,1.542 1.417,1.542 1.688,1.229 true 1.031,0.656 1.24,0.833 0.208,0.177 10 true *a 1.042,1.427 1.25,1.604 0.208,0.177 10 true *b
*a Release Cylinder Bleeder Plug Cap
*b Release Cylinder Bleeder Plug


Remove the release cylinder bleeder plug cap.


b.

Connect a vinyl tube to the release cylinder bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.*1


d.

When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.*2


e.

Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out.

NOTICE:

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.



f.

Check that all the air has been bled from the clutch line.


g.

Tighten the release cylinder bleeder plug.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


h.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



i.

Install the release cylinder bleeder plug cap.


Hide 6.INSPECT FOR BRAKE FLUID LEAK

Hide 7.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 47230 9.INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

Hide 55783E 10.INSTALL CENTER COWL TOP VENTILATOR LOUVER