|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
28100
1.INSTALL STARTER ASSEMBLY
11363A
2.INSTALL FLYWHEEL HOUSING SIDE COVER
Align the protrusion with the cylinder block sub-assembly and attach the claw as shown in the illustration to install the flywheel housing side cover.
Make sure the claw makes a click sound, indicating that it fits tightly.
Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
3.CONNECT WIRE HARNESS
4.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
51410
5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
7. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART