| *1 | WASHER | *2 | TIRE PRESSURE WARNING VALVE |
| *3 | TIRE | *4 | NUT |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning valve and transmitter removal/installation are shown below.
1.REMOVE WHEEL ASSEMBLY
2.REMOVE TIRE VALVE CAP
|
|
3.REMOVE VALVE CORE
|
|
4.REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
| *1 | Tire | - | - |
| *a | Shoe | *b | 10 to 20 mm (0.394 to 0.787 in.) |
Using an 11 mm deep socket wrench, remove the nut and washer.
Drop the tire pressure warning valve and transmitter with grommet into the tire.
The grommet may remain attached to the rim.
Using a tire remover, remove the tire from the disc wheel.
Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.
Set the tire remover shoe as shown in the illustration.
Take out the tire pressure warning valve and transmitter with grommet from the tire.
5.REMOVE GROMMET
6.REMOVE TIRE PRESSURE WARNING TRANSMITTER
Using a T10 "TORX" socket wrench, remove the bolt and tire pressure warning transmitter from the tire pressure warning valve.