| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | ECM | 89661 | - | - | - |
| 2 | NO. 1 VACUUM HOSE CONNECTOR | 44777 | ( )
|
- | - |
| 3 | FUEL TANK TO CANISTER TUBE | 77261D | - | - | - |
| 4 | ENGINE WIRE | 82121 | - | - | - |
| 5 | VACUUM PUMP ASSEMBLY | 29300 | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during vacuum pump assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Refer to the following illustration and check which type is installed to the vehicle.
| *A | for BOSCH Made | *B | except BOSCH Made |
| *a | Mark | - | - |
89661
1.REMOVE ECM
44777
2.DISCONNECT NO. 1 VACUUM HOSE CONNECTOR
|
|
| *a | Retainer | - | - |
|
Pinch |
|
Pull off |
Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.
77261D
3.SEPARATE FUEL TANK TO CANISTER TUBE
82121
4.SEPARATE ENGINE WIRE
29300
5.REMOVE VACUUM PUMP ASSEMBLY
Using an 8 mm socket wrench, remove the 3 bolts and vacuum pump assembly from the engine assembly.
Remove the No. 1 vacuum pump O-ring from the vacuum pump assembly.