Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH (for Gasoline Model LHD) › from 2021.07
RM3700E _54 Brake _093767 BRAKE SYSTEM (OTHER) _0480874 VACUUM WARNING SWITCH(for Gasoline Model LHD) A

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH(for Gasoline Model LHD)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C461338N01
2.771,1.167 3.104,1.167 false 2.26,2.531 2.594,2.531 false 3.24,3.073 3.406,3.073 3.406,3.073 3.573,2.74 false 3.219,0.979 3.5,1.333 0.281,0.354 18 false 1 2.031,2.354 2.313,2.708 0.281,0.354 18 false 2 3.031,2.896 3.313,3.25 0.281,0.354 18 false 3 2.854,2.969 3.01,3.167 0.156,0.198 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 BATTERY - - - -
2 VACUUM WARNING SWITCH ASSEMBLY 83390H - - -
3 VACUUM WARNING SWITCH GROMMET - - - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vacuum warning switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

NOTICE:

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.


HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 83390H 2.REMOVE VACUUM WARNING SWITCH ASSEMBLY

a.
C461336


Hide 3.REMOVE VACUUM WARNING SWITCH GROMMET

a.
C461337