|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
1.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
for LHD:
Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.
Fully tighten the 4 bolts in the order shown in the illustration.
Engage the 2 clamps to install the wire harness to the transmission floor shift assembly.
Connect the connector.
Engage the clamp to install the wire harness to the transmission floor shift assembly.
Connect the 2 connectors.
for RHD:
Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.
Fully tighten the 4 bolts in the order shown in the illustration.
Engage the 2 clamps to install the wire harness to the transmission floor shift assembly.
Connect the 2 connectors.
Engage the clamp to install the wire harness to the transmission floor shift assembly.
Connect the connector.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
|
|
| *1 | Adjuster Case Cover | *2 | Lock Piece |
| *3 | Adjuster Case | - | - |
Slide the adjuster case cover in the direction shown by the arrow.
Using a precision screwdriver, pull out the lock piece of the adjuster case.
| *1 | Lock Nut | *2 | Stopper |
| *a | Push in | - | - |
Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, push in the stopper.
Do not rotate the nut excessively as the interior spring may come off and the transmission control cable assembly will not be reusable.
Install the transmission control cable assembly to the transmission floor shift assembly.
After installation, check that the outer part of the stopper is as shown in the illustration.
Do not forcibly pull the transmission control cable assembly into the cabin.
Connect the transmission control cable assembly to the transmission floor shift assembly.
Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.
Connect the transmission control cable assembly so that the lock piece faces the driver side.
| *1 | Lock Piece | *2 | Adjuster Case |
| *3 | Adjuster Case Cover | - | - |
Push in the lock piece of the adjuster case to lock it.
| *1 | Transmission Control Cable Assembly |
| *2 | Lever Shaft |
When pushing in the lock piece of the adjuster case to lock it, remove your hand from the lever shaft.
When pushing in the lock piece of the adjuster case to lock it, do not move the lever shaft or transmission control cable assembly forward or backward.
Move the adjuster case cover in the direction shown by the arrow.
If the adjuster case cover is not moved far enough so that the adjuster case cover engages the lock piece, the cable will not be able to lock, and reliable shift operation will not be possible.
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY
33554
5.INSTALL SHIFT LEVER CAP
6.INSPECT SHIFT LEVER POSITION
7.ADJUST SHIFT LEVER POSITION