Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2021.07
RM3700E _58 Vehicle Interior _093147 SUPPLEMENTAL RESTRAINT SYSTEMS _0438896 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B00D512  Restraint System Passenger Disable Indicator Circuit Short to Battery  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority Test Mode / Check Mode
B00D512 Restraint System Passenger Disable Indicator Circuit Short to Battery
·

The airbag sensor assembly detects a short to B+ in the restraint system passenger disable indicator circuit when the airbag sensor assembly sends a passenger airbag indicator ON signal to the passenger airbag OFF indicator

·

Telltale light assembly malfunction

·

Airbag sensor assembly malfunction


·

Harness or connector

·

Telltale light assembly

·

Airbag sensor assembly


Comes on SRS Airbag A Does not apply to test/check mode

WIRING DIAGRAM

C414742E05
5.49,0.844 6.104,1.042 0.615,0.198 10 false P-AB 1.542,0.844 1.979,1.031 0.438,0.188 10 false P-AB 0.615,0.594 1.229,0.792 0.615,0.198 10 false IGR 5.229,0.844 5.458,1.031 0.229,0.188 10 false 34 2.031,0.833 2.646,1.031 0.615,0.198 10 false 2 0.781,1.156 1.906,1.823 1.125,0.667 10 false Passenger Airbag OFF Indicator 0.375,1.896 0.99,2.094 0.615,0.198 10 false H8 5.333,1.906 5.948,2.104 0.615,0.198 10 false H14 5.323,2.073 7.01,2.417 1.688,0.344 10 false Airbag Sensor Assembly 0.385,2.094 3.115,2.719 2.729,0.625 10 false Telltale Light Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the cable to the auxiliary battery terminal, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART




PROCEDURE

1.CHECK CONNECTION OF CONNECTORS

Pre-procedure1

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



Procedure1

a.

Check that the connectors are properly connected to the airbag sensor assembly and telltale light assembly.

OK:

The connectors are properly connected.


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

2.CHECK CONNECTORS

NG

CONNECT CONNECTORS PROPERLY

2.CHECK CONNECTORS

Pre-procedure1

a.

Disconnect the connectors from the airbag sensor assembly and telltale light assembly.


Procedure1

C422859C02
1.521,0.563 1.521,0.99 false 2.625,0.969 2.958,1.313 0.333,0.344 10 false *2 1.448,0.385 1.781,0.542 0.333,0.156 10 false *3 0.406,0.969 0.615,1.208 0.208,0.24 10 false *1
*1 Telltale Light Assembly
*2 Airbag Sensor Assembly
*3 Wire Harness


a.

Check that the terminals of the connectors are not deformed or damaged.

OK:

The terminals are not deformed or damaged.


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

3.CHECK WIRE HARNESS (SHORT TO B+)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK WIRE HARNESS (SHORT TO B+)

Pre-procedure1

a.

Connect the cable to the negative (-) auxiliary battery terminal.


b.

Turn the ignition switch to ON.


Procedure1

C422880C02
0.75,0.427 1.115,0.667 0.365,0.24 0.771,3.729 1.135,3.969 0.365,0.24 1.635,2.99 1.635,2.74 false 2.167,1.802 1.958,1.302 true 1.563,3.917 1.25,4.302 true 0.417,2.583 0.667,2.833 0.25,0.25 10 false *1 2.75,2.583 3.135,2.906 0.385,0.323 10 false *2 0.656,0.167 1.021,0.417 0.365,0.25 10 false *b 0.646,3.417 0.896,3.667 0.25,0.25 10 false *a 1.573,3.021 1.969,3.25 0.396,0.229 10 false *3 2.354,2.583 2.583,2.833 0.229,0.25 10 false A 1.99,2.583 2.167,2.823 0.177,0.24 10 false B 1.135,2.583 1.333,2.833 0.198,0.25 10 false C 0.771,2.583 0.917,2.833 0.146,0.25 10 false D 0.802,0.458 1.135,0.656 0.333,0.198 10 false H14 2.208,1.729 2.74,1.958 0.531,0.229 10 false P-AB 0.854,3.76 1.115,3.958 0.26,0.198 10 false H8 0.865,4.219 1.26,4.427 0.396,0.208 10 false P-AB
*1 Telltale Light Assembly
*2 Airbag Sensor Assembly
*3 Wire Harness
*a Front view of wire harness connector
(to Telltale Light Assembly)
*b Front view of wire harness connector
(to Airbag Sensor Assembly)


a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(H8,H14)Location & Routing

Click Connector(H8)Instrument Panel>Instrument Panel Wire / Speaker Wire>Telltale Light Assembly

Click Connector(H14)Instrument Panel>Instrument Panel Wire / Speaker Wire>Airbag Sensor Assembly

H8-2 (P-AB) or H14-34 (P-AB) - Body ground Ignition switch ON Below 1 V


Result:
Proceed to
OK
NG



Post-procedure1

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.




OK

4.CHECK TELLTALE LIGHT ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK TELLTALE LIGHT ASSEMBLY

Pre-procedure1

a.

Connect the connector to the telltale light assembly.


b.

Connect the cable to the negative (-) auxiliary battery terminal.


c.

Turn the ignition switch to ON.


Procedure1

C422881C02
0.604,1.948 1.021,2.198 0.417,0.25 2.083,2.875 2.594,2.479 true 1.5,1.042 1.5,0.625 false 0.406,0.458 0.667,0.75 0.26,0.292 10 false *1 2.802,0.458 3.167,0.75 0.365,0.292 10 false *2 1.448,1.052 1.75,1.333 0.302,0.281 10 false *3 0.469,1.552 0.917,2.146 0.448,0.594 10 false *a 0.698,1.99 1.031,2.271 0.333,0.281 10 false H14 2.615,2.396 3.01,2.688 0.396,0.292 10 false P-AB 2.354,0.469 2.729,0.781 0.375,0.313 10 false A 1.99,0.469 2.365,0.781 0.375,0.313 10 false B 0.927,0.469 1.302,0.781 0.375,0.313 10 false C 0.771,0.469 1.146,0.781 0.375,0.313 10 false D
*1 Telltale Light Assembly
*2 Airbag Sensor Assembly
*3 Wire Harness
*a Front view of wire harness connector
(to Airbag Sensor Assembly)


a.

Check the passenger airbag OFF indicator according to the conditions in the table below.

OK:
Terminal Connection Switch Condition Specified Condition
H14-34 (P-AB) - Body ground Ignition switch ON Passenger airbag OFF indicator comes on


Result:
Proceed to
OK
NG



Post-procedure1

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.




OK

NG