| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | ADJUST STEERING WHEEL POSITION | - | ( )
|
- | - |
| 2 | LOWER STEERING COLUMN COVER | 45287 | ( )
|
- | - |
| 3 | UPPER STEERING COLUMN COVER | 45286B | - | - | - |
| 4 | TURN SIGNAL SWITCH | 84329 | ( )
|
- | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
45286B
3.REMOVE UPPER STEERING COLUMN COVER
84329
4.REMOVE TURN SIGNAL SWITCH
|
Remove in this Direction | - | - |
Remove the 2 screws.
Turn the steering wheel assembly to the right.
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the turn signal switch as shown in the illustration.
If the claw is pulled with excessive force, it may break.