Home › Engine / Hybrid System › STOP AND START › VACUUM SENSOR ASSEMBLY › from 2021.07
RM3700E _51 Engine / Hybrid System _105429 STOP AND START _0482032 VACUUM SENSOR ASSEMBLY A

STOP AND START  VACUUM SENSOR ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A495596N01
0.948,0.75 1.281,0.75 false 2.854,0.969 3.083,0.5 3.083,0.5 3.25,0.5 false 3.25,1 3.75,0.667 3.75,0.667 3.917,0.667 false 0.771,0.594 1.052,0.948 0.281,0.354 18 false 1 3.333,0.344 3.615,0.698 0.281,0.354 18 false 2 4.083,0.5 4.365,0.854 0.281,0.354 18 false 3 3.979,0.552 4.135,0.75 0.156,0.198 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 BRAKE MASTER CYLINDER SUB-ASSEMBLY 47201 - - -
2 VACUUM SENSOR ASSEMBLY 89420H - - -
3 VACUUM SENSOR GROMMET - - - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the eco run vehicle converter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 47201 1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 89420H 2.REMOVE VACUUM SENSOR ASSEMBLY

a.
A485875


Hide 3.REMOVE VACUUM SENSOR GROMMET