Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2021.07
RM3700E _59 Vehicle Exterior _093283 LIGHTING (EXT) _0440204 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
E460540N01
3.25,3.104 3.354,3.365 3.354,3.365 3.521,3.365 false 5.24,2.74 4.99,2.74 false 4.729,2.969 4.729,3.302 false 3.583,3.198 3.865,3.5 0.281,0.302 18 false 3 5.604,2.573 5.885,2.927 0.281,0.354 18 false 2 4.75,3.333 5.031,3.688 0.281,0.354 18 false 1 4.615,3.365 5.021,3.646 0.406,0.281 10 false ● 2.729,3.469 3,3.75 0.271,0.281 10 false x2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 STOP LIGHT SWITCH MOUNTING ADJUSTER 84345 - - -
2 STOP LIGHT SWITCH ASSEMBLY 84340 (Click here) - -
3 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55606 - - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84345 1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 2.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E460541C01
2,1.604 1.677,1.25 true 0.708,0.188 0.99,0.542 0.281,0.354 18 false i 6.792,0.229 7.063,0.531 0.271,0.302 18 false ii 1.823,2.052 2.104,2.406 0.281,0.354 18 false iv 2.052,1.563 2.375,1.802 0.323,0.24 10 false *1 5.052,1.802 5.375,2.042 0.323,0.24 10 false *a 5.688,1.583 5.958,1.885 0.271,0.302 18 false iii
*1 Stop light switch mounting adjuster - -
*a Protrusion Amount Measurement Area - -
V113147

Install in this Direction - -


i.

Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

NOTICE:

Do not depress the brake pedal.



ii.

Turn the stop light switch assembly clockwise by approximately one fourth of a rotation.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


iii.

Check the protrusion amount of the shaft.

Protrusion amount of the shaft:
Area Measurement Area Measurement
a 0.5 to 2.6 mm (0.0197 to 0.102 in.) - -



iv.

Connect the connector.

NOTICE:

Check that the stop light does not come on when the brake pedal is not depressed.




Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY