The engine stop and start ECU detects whether the engine hood is open or closed based on a signal received from the engine hood courtesy switch built into the hood lock assembly.
The engine stop and start ECU prohibits starting of the engine by stop and start control and changes the mode to "stalled" if the engine hood is open with the clutch pedal is released while the engine is stopped by stop and start control.
For wire harness and connector inspection procedures and precautions, refer toGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Before performing this step, check that the engine hood can be opened by pulling the hood lock control cable.
Enter the following menus.
| Tester Display |
|---|
| Hood Courtesy Switch |
According to the display on the GTS, read the Data List.
| GTS Display | Condition | Normal Condition |
|---|---|---|
| Hood Courtesy Switch | Engine hood closed | ON |
| Engine hood open | OFF |
| Result |
|---|
| OK |
| NG |
OK
NG
Inspect the engine hood courtesy switch (hood lock assembly).
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the A58 engine hood courtesy switch (hood lock assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A58)Location & Routingewd_type=routing;type=c;code=A58 Click Connector(A58)Engine Compartment>Engine Room Main Wire>Hood Lock Assemblyewd_type=component;type=c;code=A58;pinno=2 |
||
| A58-2 (E) - Body ground | Always | Below 1 Ω |
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the A67 engine stop and start ECU connector.
Disconnect the A58 engine hood courtesy switch (hood lock assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A67,A58)Location & Routingewd_type=routing;type=c,c;code=A67,A58 Click Connector(A67)Instrument Panel>Engine Room Main Wire>Engine Stop and Start ECUewd_type=component;type=c;code=A67;pinno=7 Click Connector(A58)Engine Compartment>Engine Room Main Wire>Hood Lock Assemblyewd_type=component;type=c;code=A58;pinno=1 |
||
| A67-7 (BNT1) - A58-1 (+) | Always | Below 1 Ω |
| A67-7 (BNT1) - Body ground | Always | 10 kΩ or higher |
| A58-1 (+) - Body ground | Always | 10 kΩ or higher |
| Result |
|---|
| OK |
| NG |
OK
NG