| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | WINDSHIELD WIPER MOTOR ASSEMBLY | 85110 | ( )
|
- | - |
| 9 | WINDSHIELD WIPER MOTOR ASSEMBLY | 85110 | ( )
|
- | - |
| 10 | NO. 1 WINDSHIELD WIPER SHAFT COVER | 85112A | - | - | - |
| *A | for LHD | *B | for RHD |
| *C | for TMMF Made | - | - |
| *1 | WINDSHIELD WIPER LINK ASSEMBLY | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure below is for LHD vehicles.
85292B
1.REMOVE FRONT WIPER ARM HEAD CAP
|
Remove in this Direction | - | - |
Using a screwdriver with its tip wrapped with protective tape, disengage the claws to remove the front wiper arm head cap.
Use the same procedure for the RH side and LH side.
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
53867
4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
|
Remove in this Direction | - | - |
53866
5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Use the same procedure as for the LH side.
55708
6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
7.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
|
|
| *a | Motor Grommet | - | - |
|
Remove in this Direction | - | - |
85110
8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)
| *a | No. 1 Windshield Wiper Link Rod | *b | Pivot of Windshield Wiper Motor Assembly |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped in protective tape, separate the No. 1 windshield wiper link rod from the pivot of the windshield wiper motor assembly as shown in the illustration.
Remove the 3 bolts.
Remove the windshield wiper motor assembly as shown in the illustration.
85110
9.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)
| *a | No. 1 Windshield Wiper Link Rod | *b | Pivot of Windshield Wiper Motor Assembly |
Using a screwdriver with its tip wrapped in protective tape, separate the No. 1 windshield wiper link rod from the pivot of the windshield wiper motor assembly as shown in the illustration.
Using a T30 "TORX" socket wrench, remove the 2 screws.
Disengage the guides to remove the windshield wiper motor assembly.
85112A
10.REMOVE NO. 1 WINDSHIELD WIPER SHAFT COVER (for TMMF Made)