|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Lithium soap base glycol grease | - | - |
47547B
1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
|
|
31478B
2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
3.INSTALL PISTON SEAL
| *1 | Piston Seal | *2 | Front Disc Brake Cylinder |
|
Lithium Soap Base Glycol Grease | - | - |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
Install the piston seal to the front disc brake cylinder.
Securely install the piston seal into the groove of the front disc brake cylinder.
47731
4.INSTALL FRONT DISC BRAKE PISTON
| *1 | Cylinder Boot | *2 | Front Disc Brake Piston |
|
Lithium Soap Base Glycol Grease | - | - |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston.
Install the cylinder boot to the front disc brake piston.
Securely install the cylinder boot into the groove of the front disc brake piston.
Install the front disc brake piston to the front disc brake cylinder.
Do not forcibly install the front disc brake piston into the front disc brake cylinder.
5.INSTALL CYLINDER BOOT
|
|
| *1 | Cylinder Boot | *2 | Front Disc Brake Piston |
| *3 | Front Disc Brake Cylinder | - | - |
Install the cylinder boot to the front disc brake cylinder as shown in the illustration.