| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT WHEEL | - | - | - | - |
| 2 | FRONT DISC BRAKE CYLINDER ASSEMBLY | - | ( )
|
- | - |
| 3 | FRONT DISC BRAKE PAD | - | - | - | - |
| 4 | FRONT DISC BRAKE ANTI-SQUEAL SHIM | - | - | - | - |
| *1 | FRONT BRAKE PAD RADIAL SPRING | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.SEPARATE FRONT DISC BRAKE CYLINDER ASSEMBLY
|
|
Hold the front disc brake cylinder slide pin (lower side) and remove the bolt.
Do not kink or damage the brake line.
Pull the front disc brake cylinder assembly upward.
3.REMOVE FRONT DISC BRAKE PAD
4.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM