| *1 | FRONT BRAKE PAD RADIAL SPRING | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL FRONT DISC BRAKE ANTI-SQUEAL SHIM
|
|
2.INSTALL FRONT DISC BRAKE PAD
|
|
| *a | Inner Side | *b | Outer Side |
| *c | Pad Wear Indicator Plate | - | - |
Install the 2 front brake pad radial springs to each front disc brake pad.
Install the 2 front disc brake pads to the front disc brake cylinder mounting.
Keep the friction surfaces of the front disc brake pads and front disc free from oil and grease.
Install the front disc brake pad so that the pad wear indicator plate is mounted on the upper and lower side of the vehicle.
3.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY
Using SST, push back the front disc brake piston.
Make sure that the brake fluid does not overflow from the reservoir.
Do not forcibly push in the front disc brake piston.
Hold the front disc brake cylinder slide pin (lower side) and install the front disc brake cylinder assembly to the front disc brake cylinder mounting with the bolt.
Do not reuse the bolts.
If the bolts are reused, the front disc brake cylinder assembly could come off, which could cause an accident.
4.INSPECT BRAKE FLUID LEVEL IN RESERVOIR
for HV Model: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model TMMF Made)>ON-VEHICLE INSPECTION
for Gasoline Model: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for Gasoline Model)>ON-VEHICLE INSPECTION
5.INSTALL FRONT WHEEL