| ● | Non-reusable part | - | - |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
Make sure to read the precautions of the electric parking brake system before removing the rear brake assembly.
for HV Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMMF Made)>PRECAUTION
for Gasoline Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model TMMF Made)>PRECAUTION
2.PERFORM REAR BRAKE PAD REPLACEMENT MODE
for HV Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMMF Made)>TEST MODE PROCEDURE
for Gasoline Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model TMMF Made)>TEST MODE PROCEDURE
3.REMOVE REAR WHEEL
47850
5.SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY
|
|
Hold the rear disc brake cylinder slide pin (lower side) and remove the bolt.
Do not kink or damage the brake line.
Pull the rear disc brake cylinder assembly upward.
04466
6.REMOVE REAR DISC BRAKE PAD
04946
7.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM