| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | REAR WHEEL | - | - | - | - |
| 3 | BRAKE FLUID | - | - | ( )
|
- |
| 4 | REAR FLEXIBLE HOSE | 47319F | ( )
|
- | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
Make sure to read the precautions of the electric parking brake system before removing the rear brake assembly.
for HV Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMMF Made)>PRECAUTION
for Gasoline Model: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model TMMF Made)>PRECAUTION
2.REMOVE REAR WHEEL
3.DRAIN BRAKE FLUID
|
|
47319F
4.REMOVE REAR FLEXIBLE HOSE
Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.
Remove the bolt and separate the rear flexible hose from the rear axle beam assembly.
Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
Remove the clip and rear flexible hose.