Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made) › from 2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0483473 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made)  DTC CHECK / CLEAR  


DTC CHECK


a.

Turn the ignition switch off.


b.

Read the DTCs using the GTS.

Chassis > Brake Booster > Trouble Codes
50001 466
Chassis > Brake/EPB > Trouble Codes
50001 435

c.

Check the details of the DTCs.

NOTICE:
·

Make sure to clear the DTCs after repair.

·

The electronically controlled brake system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the electronically controlled brake system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

System Proceed to
Electric Parking Brake System (Click here)



HINT:
GTS Display Description
Test Failed Shows the malfunction judgment results during the current trip.
Pending* Shows a temporary malfunction. (Indicates the possibility of a malfunction when no DTC is confirmed.)
Confirmed Shows the DTCs confirmed up to now (The number of current trips differs for each DTC.)

*: As 2 trip DTCs do not exist for the electronically controlled brake system, current DTCs are stored simultaneously.


·

Freeze frame data is stored for each of the latest result DTCs and confirmed DTCs.

·

Refer to the diagnostic trouble code chart and perform the necessary troubleshooting procedures.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>DIAGNOSTIC TROUBLE CODE CHART




d.

Check the freeze frame data.

i.

If a DTC is stored, check the corresponding freeze frame data to gain an understanding of the vehicle condition at the time.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>FREEZE FRAME DATA




CHECK TIME STAMP


HINT:

By checking Time Stamp, the time and order in which DTCs were stored in an ECU can be checked.


a.

Turn the ignition switch off.


b.

Enter the following menus: Health Check.


c.

Perform the following steps when the data setting screen is displayed.


d.

Select the systems for which to perform Health Check and check for time stamp data.

Selectable items:
·

Powertrain

·

Chassis

·

Body

·

Store All Data



e.

Select "Yes" when "Would you like to include Time Stamp Data?" is displayed.

HINT:

If "Yes" is not selected, time stamp data will not be stored.



f.

After Health Check has completed, select "Time Stamp Data" to display the Time Stamp screen.


g.

Select the desired system from the drop-down list on the bottom of the Time Stamp screen.


h.

Check the order and time which DTCs were stored for the selected system.



DTC CLEAR


a.

Turn the ignition switch off.


b.

Operate the GTS to clear the codes.

Chassis > Brake Booster > Trouble Codes
50001 466
Chassis > Brake/EPB > Clear DTCs
50002 435

c.

Press the DTC clear button.

NOTICE:

When DTCs are cleared, all data related to the DTCs is also cleared.


HINT:

If the malfunction continues, the DTCs will be stored again when the detection conditions are met.