Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ACTUATOR (for TMMF Made 2WD) › from 2021.07
RM3700E _54 Brake _093729 PARKING BRAKE _0483915 ELECTRIC PARKING BRAKE ACTUATOR(for TMMF Made 2WD) A

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR(for TMMF Made 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
C464301N01
0.177,1.323 0.844,1.49 0.667,0.167 0.135,1.281 0.885,1.531 0.75,0.25 2.01,1.417 2.344,1.417 false 1.188,1.448 1.188,1.823 false 2.792,0.583 3.177,0.583 false 0.51,1.313 0.51,1.146 0.51,1.146 0.667,1.031 false 4.615,4.792 4.948,4.792 false 2.396,1.302 2.552,1.5 0.156,0.198 10 false ● 1.208,1.823 1.49,2.177 0.281,0.354 18 false 1 3.479,0.417 3.76,0.771 0.281,0.354 18 false 2 0.656,1.073 0.969,1.271 0.313,0.198 10 false x2 0.24,1.333 1.188,1.479 0.948,0.146 8 false 10 (102, 7) 4.406,4.646 4.688,5 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PARKING BRAKE ACTUATOR ASSEMBLY 46310B (Click here) - -
2 NO. 2 PARKING BRAKE WIRE ASSEMBLY 890C0A (Click here) - -
3 REAR WHEEL - - - -

V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) ● Non-reusable part
V100135

Lithium soap base glycol grease - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 46310B 1.INSTALL PARKING BRAKE ACTUATOR ASSEMBLY

a.
C464302N01
0.365,0.01 0.719,0.313 0.354,0.302 18 true i, ii 3.917,0.021 4.375,0.344 0.458,0.323 18 false iii

i.

Apply a light coat of lithium soap base glycol grease to a new O-ring.


ii.

Install the O-ring to the rear disc brake cylinder assembly.

NOTICE:

Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.



iii.

Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



Hide 890C0A 2.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Z101186

NOTICE:
·

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this work.

·

Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.




Hide 3.INSTALL REAR WHEEL