Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type with TAS Type) › from 2021.07
RM3700E _56 Audio / Visual / Telematics _093686 AUDIO / VIDEO _0484174 AUDIO AND VISUAL SYSTEM(for Radio and Display Type with TAS Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type with TAS Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the brake actuator assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E463309E03
4.885,1.938 6.583,2.49 1.698,0.552 10 false Radio and Display Receiver Assembly 4.885,1.781 5.375,2.219 0.49,0.438 10 false H80 0.573,1.771 1.063,2.208 0.49,0.438 10 false A39 0.573,1.927 2.573,2.448 2,0.521 10 false Brake Actuator Assembly 4.854,1 5.344,1.438 0.49,0.438 10 false 20 5.125,1.104 5.615,1.542 0.49,0.438 10 false PKB 1.479,1.104 1.969,1.542 0.49,0.438 10 false PKB 1.865,0.99 2.354,1.427 0.49,0.438 10 false 35

PROCEDURE

1.CHECK PARKING BRAKE SWITCH ASSEMBLY (OPERATION CHECK)
a.
E463241

Enter the "System Parameters" screen. Refer to system parameter list in System Parameter.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type with TAS Type)>DTC CHECK / CLEAR


b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK
Parking Brake Condition Display
Applied ON
Released OFF

HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK BRAKE WARNING LIGHT
2.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the H80 radio and display receiver assembly connector.


b.

Disconnect the A39 brake actuator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(H80,A39)Location & Routing

Click Connector(H80)Instrument Panel>Instrument Panel Wire / Speaker Wire>Radio & Display Receiver Assembly

Click Connector(A39)Engine Compartment>Engine Room Main Wire>Brake Actuator Assembly

H80-20 (PKB) - A39-35 (PKB) Always Below 1 Ω
H80-20 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR