Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY › from 2021.07
RM3700E _58 Vehicle Interior _093147 SUPPLEMENTAL RESTRAINT SYSTEMS _0443940 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

B621790N01
2.615,0.448 2.948,0.448 false 6.167,1.563 6.5,1.563 false 0.802,2.135 0.802,2.469 false 4.698,0.656 4.698,0.99 false 6.458,0.188 6.792,0.188 false 3.615,1.917 3.615,2.25 false 1.552,1.365 1.552,1.698 false 1.844,1.125 2,1.458 2,1.458 2.167,1.458 false 3.583,2.26 3.74,2.458 0.156,0.198 10 false ● 1.615,1.25 1.927,1.448 0.313,0.198 10 false x2 1.917,1.021 2.229,1.219 0.313,0.198 10 false x2 4.656,1 4.813,1.198 0.156,0.198 10 false ● 3.719,1.771 4.031,1.969 0.313,0.198 10 false x2 4.771,0.594 5.083,0.792 0.313,0.198 10 false x2 6.292,0.042 6.885,0.333 0.594,0.292 18 false 1 6.781,1.417 7.031,1.74 0.25,0.323 18 false 3 2.406,0.313 3,0.604 0.594,0.292 18 false 4 0.74,2.49 1.333,2.781 0.594,0.292 18 false 2 2.219,1.354 2.531,1.552 0.313,0.198 10 false *2 1.5,1.719 1.813,1.917 0.313,0.198 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 SEPARATE TYPE FRONT SEATBACK COVER WITH PAD - - - -
3 FRONT SEAT AIRBAG ASSEMBLY 73920A (Click here) - -
4 FRONT SEAT CENTER AIRBAG ASSEMBLY 739H0 (Click here) - -

*1 SEAT COVER HANGER *2 SEATBACK COVER HOOK
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B394717

There is risk of injury.



NOTICE:

If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system*1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -

·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the LH and RH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

(Click here)



Hide 2.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

·

Front seat assembly (for Manual seat):

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY

·

Front seat assembly (for Power seat):

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY


Hide 73910A 3.REMOVE FRONT SEAT AIRBAG ASSEMBLY

Z101186

CAUTION:
·
B399378N05
1.135,1.771 1.563,1.563 true 0.948,1.708 1.26,1.906 0.313,0.198 10 false *a

When storing the front seat airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B620958N01
3.344,1.115 3.5,1.438 0.156,0.323 18 true i 4.333,0.198 4.51,0.521 0.177,0.323 18 false ii

i.

Disengage the clamp.


ii.

Remove the 2 nuts and front seat airbag assembly.

CAUTION:
·

Do not reuse the nut.

·

If the installation surface or surrounding area of the front seat airbag is deformed or damaged, replace the front seatback frame sub-assembly with a new one.





Hide 739H0 4.REMOVE FRONT SEAT CENTER AIRBAG ASSEMBLY

Z101186

CAUTION:
·
B399378N05
1.135,1.771 1.563,1.563 true 0.948,1.708 1.26,1.906 0.313,0.198 10 false *a

When storing the front seat center airbag assembly, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B620951N01
4.385,1.146 4.521,1.458 0.135,0.313 18 true i 2.5,0.323 2.635,0.635 0.135,0.313 18 false ii

i.

Disengage the clamp.


ii.

Remove the 2 nuts and front seat airbag assembly.

CAUTION:
·

Do not reuse the nut.

·

If the installation surface or surrounding area of the front seat airbag is deformed or damaged, replace the front seatback frame sub-assembly with a new one.