| *A | for Driver Side | *B | for Front Passenger Side |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
8983A
1.INSTALL SIDE AIRBAG PRESSURE SENSOR
| *A | w/ Entry and Start System | *B | w/o Entry and Start System |
| *a | Illumination off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector
Engage the claw to hold the side airbag pressure sensor in place.
If the side airbag pressure sensor has been dropped, replace it with a new one.
Install a new nut.
When installing the side airbag pressure sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
Do not reuse the nut.
Check that there is no looseness in the installation parts of the side airbag pressure sensor.
67831
2.INSTALL FRONT DOOR SERVICE HOLE COVER
68171B
3.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP
67601
4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
67655
5.INSTALL FRONT DOOR TRIM GARNISH
6.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
7.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
67491A
8.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
10. PERFORM DIAGNOSTIC SYSTEM CHECK
12. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART