| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT SEAT OUTER BELT ASSEMBLY | 73210 | ( )
|
- | - |
| 2 | CENTER PILLAR UPPER GARNISH | 62411B | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| *A | for Gasoline Model | *B | for HV Model |
| *C | for LH Side | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for RHD and LHD.
The following procedure is for LHD.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
73210
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
| *A | w/o Entry and Start System | *B | w/ Entry and Start System |
| *a | Illumination off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
| *A | for TMC Made | *B | for TMMF Made |
Engage the guides to temporarily install the front seat outer belt assembly with the 2 bolts.
Tighten bolt (A) and then bolt (B).
Connect the shoulder anchor of the front seat outer belt assembly with the bolt.
Connect the floor anchor of the front seat outer belt assembly with the bolt.
Check that the ELR locks.
This check should be performed with the front seat outer belt assembly installed to the vehicle.
Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
| *A | for TMMF Made | *B | for TMC Made |
Connect the pretensioner connector.
Refer to How to Connect or Disconnect Airbag Connector:
62411B
2.INSTALL CENTER PILLAR UPPER GARNISH
62413A
3.INSTALL CENTER PILLAR LOWER GARNISH
73210
4.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
73233
5.INSTALL LAP BELT OUTER ANCHOR COVER
62311B
6.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
67913B
7.INSTALL FRONT DOOR SCUFF PLATE
62331A
8.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
67917F
9.INSTALL REAR DOOR INSIDE SCUFF PLATE
76973F
10.INSTALL REAR UNDER SIDE COVER (for HV Model LH Side)
11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
12. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART