| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C052C17 | ABS Pump Motor Control Circuit Voltage Above Threshold | The ABS motor voltage is 18.5 V or more for 0.2 seconds or more. | ·
Wire harness or connector ·
Brake actuator assembly |
Brake/EPB | A |
| C052C1C | ABS Pump Motor Control Circuit Voltage Out of Range | An open or short in the ABS motor circuit is detected for 2 seconds or more. | Brake actuator assembly | Brake/EPB | A |
After replacing the brake actuator assembly, perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Inspect the fuses for circuits related to this system before performing the following procedure.
Procedure1
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Pre-procedure1
Disconnect the A38 skid control ECU (brake booster with master cylinder assembly) connector.
Disconnect the A95 brake actuator assembly connector.
Procedure2
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Procedure3
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A38,A95)Location & Routingewd_type=routing;type=c,c;code=A38,A95 Click Connector(A38)Engine Compartment>Engine Room Main Wire>Brake Booster with Master Cylinder Assemblyewd_type=component;type=c;code=A38;pinno=40 Click Connector(A95)Engine Compartment>Engine Room Main Wire>Brake Actuator Assemblyewd_type=component;type=c;code=A95;pinno=10 |
||
| A38-40 (+BM) - A95-10 (+BM) | Always | Below 1 Ω |
| A38-40 (+BM) or A95-10 (+BM) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A95)Location & Routingewd_type=routing;type=c;code=A95 Click Connector(A95)Engine Compartment>Engine Room Main Wire>Brake Actuator Assemblyewd_type=component;type=c;code=A95;pinno=1 |
||
| A95-1 (MGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model TMC Made RHD)>REMOVAL
NG