If a malfunction is detected in the power supply circuit, the skid control ECU (brake booster with master cylinder assembly) power source voltage drops, or there is insufficient voltage to operate the main relay, the skid control ECU (brake booster with master cylinder assembly) will store these DTCs.
If the auxiliary battery voltage is temporarily low, these DTCs may be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C102014 | Ignition Switch On/Start Position Circuit Short to Ground or Open | All the following conditions are met for 4 seconds or more
·
The IGR terminal voltage is less than 3.5 V and the IGP terminal voltage is 9.5 V or more. ·
Communication with the hybrid vehicle control ECU is normal, or a vehicle speed is 10 km/h (6 mph) or more and the IGR terminal voltage is less than 3.5 V. ·
The IGP terminal voltage is 9.5 V or more. |
·
Open or short in IGP circuit ·
Open or short in IGR circuit ·
Improperly connected connector, deformation or corrosion of terminals ·
Skid control ECU (brake booster with master cylinder assembly) |
Brake/EPB | A |
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Inspect the fuses for circuits related to this system before performing the following procedure.
Pre-procedure1
Turn the ignition switch off.
Procedure1
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Pre-procedure2
Disconnect the A38 skid control ECU (brake booster with master cylinder assembly) connector.
Procedure2
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Procedure3
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A38)Location & Routingewd_type=routing;type=c;code=A38 Click Connector(A38)Engine Compartment>Engine Room Main Wire>Brake Booster with Master Cylinder Assemblyewd_type=component;type=c;code=A38;pinno=23,9 |
||
| A38-23 (IGR) - Body ground | Ignition switch ON | 11 to 14 V |
| A38-9 (IGP) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG