The skid control ECU (brake booster with master cylinder assembly) stores the individual characteristics of each linear solenoid built into the brake booster with master cylinder assembly. Based on the stored information, the skid control ECU (brake booster with master cylinder assembly) calibrates the individual differences and controls systems.
The skid control ECU (brake booster with master cylinder assembly) receives the park (P) signal from the hybrid vehicle control ECU through the CAN communication system.
These DTCs are cleared when the linear solenoid valve offset learning results are normal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C134551 | Linear Solenoid Valve Offset Learning Not Programmed | The linear solenoid valve offset learning value is not stored. | Perform linear solenoid valve offset learning and check for DTCs. If no DTCs are output again, the valve is normal. | Brake/EPB | A |
| C134554 | Linear Solenoid Valve Offset Learning Missing Calibration | The linear solenoid valve offset learning value cannot be obtained. | ·
Perform linear solenoid valve offset learning and check for DTCs. If no DTCs are output again, the valve is normal. ·
Skid control ECU (brake booster with master cylinder assembly) |
Brake/EPB | A |
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Before performing linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization, DTC C124A00 will be output.
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Check that DTCs other than C134551 and C134554 are not output.
| Result | Proceed to |
|---|---|
| Only C134551 or C134554 is output | A |
| None of the above conditions are met | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Check and ensure the following conditions required for performing linear solenoid valve offset learning and then perform linear solenoid valve offset learning.
| Tester Display |
|---|
| ECB Utility |
The auxiliary battery voltage is 11 to 15.5 V when the ignition switch ON (READY).
The brake actuator (brake booster with master cylinder assembly) is not hot.
The hybrid control system is not malfunctioning.
The shift state indicator shows that the vehicle shift state is park (P).
The READY light in the combination meter assembly is illuminated.
The brake pedal is not depressed.
The parking brake is released.
DTC C145151 is not output. (If it is output, bleed the air from the high-pressure tube.)
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Pre-procedure1
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Procedure1
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C134551 and C134554 are not output | A |
| C134551 or C134554 is output | B |
Post-procedure1
None
A
B