| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | LUMBAR POWER SEAT SWITCH | 84922A | - | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lumbar power seat switch removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad, separate type front seatback cover and front seatback pad with cover with the necessary parts in accordance with the extent of the collision damage.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD.
The following procedure is for LHD.
Lumbar Power Seat Switch is available only on the driver side.
1. PRECAUTION
Some of these service operations affect the SRS airbag system. Read precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
2.REMOVE FRONT SEAT ASSEMBLY
72494A
3.REMOVE VERTICAL ADJUSTING HANDLE
72551B
4.REMOVE RECLINING HINGE COVER
72525A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE
71849
6.REMOVE SEAT ADJUSTER COVER CAP
84922A
8.REMOVE LUMBAR POWER SEAT SWITCH