|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
High-temperature grease |
| *1 | STARTER DRIVE HOUSING ASSEMBLY | - | - |
28021
1.INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
| *a | Cutout | *b | Protrusion |
|
High-temperature Grease | - | - |
Apply high-temperature grease to the pinion drive lever.
Apply approximately 0.1 g of high-temperature grease to each section.
Align the cutout of the starter drive housing assembly with the protrusion of the starter center bearing clutch sub-assembly and install the starter center bearing clutch sub-assembly.
Install the rubber seal to the starter drive housing assembly.
2.INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
|
|
| *a | Cutout | *b | Protrusion |
3.INSTALL STARTER BRUSH HOLDER ASSEMBLY
28160
4.INSTALL STARTER ARMATURE ASSEMBLY
Install the starter yoke assembly while holding down the starter armature assembly and starter brush holder assembly with the handle of a hammer.
5.INSTALL STARTER YOKE ASSEMBLY
| *a | Cutout | *b | Protrusion |
Align the cutout of the starter yoke assembly with the protrusion of the starter center bearing clutch sub-assembly.
Install the starter yoke assembly with the 3 through bolts.
28226B
6.INSTALL MAGNET STARTER SWITCH ASSEMBLY
| *1 | Pinion Drive Lever | *2 | Hook |
| *a | Terminal C | - | - |
Hang the hook of the magnet starter switch assembly on the pinion drive lever.
Push down the back of the magnet starter switch assembly and connect it to terminal C.
Connect the magnet starter switch assembly securely to terminal C.
Check that the parts are free of foreign matter, oil or grease.
Install the magnet starter switch assembly with the 2 bolts.