| *1 | GENERATOR DRIVE END FRAME | - | - |
| ● | Non-reusable part | - | - |
27416
1.REMOVE GENERATOR PULLEY CAP
|
|
27415
2.REMOVE GENERATOR PULLEY WITH CLUTCH
| *1 | Rotor Shaft | *2 | Generator Pulley with Clutch |
| *a | Turn | *b | Hold |
Secure the generator assembly in a vise between aluminum plates.
Do not overtighten the vise.
Fit the rotor shaft end into SST (A).
Fit SST (B) to the generator pulley with clutch.
Securely attach SST to the generator pulley with clutch and rotor shaft.
Loosen the generator pulley with clutch by turning SST (A) as shown in the illustration.
Check that the generator assembly is secured in the vise tightly.
Hold SST tightly during the operation.
27039
3.REMOVE GENERATOR REAR END COVER
27387B
4.REMOVE GENERATOR TERMINAL INSULATOR
27700A
5.REMOVE GENERATOR REGULATOR ASSEMBLY
27360
6.REMOVE GENERATOR COIL ASSEMBLY
| *a | Hold | *b | Turn |
Remove the 4 bolts.
Using SST, remove the generator coil assembly.
27444
7.REMOVE GENERATOR BEARING COVER PACKING
|
|
27330
8.REMOVE GENERATOR ROTOR ASSEMBLY
|
|
9.INSPECT GENERATOR DRIVE END FRAME BEARING
27312
10.REMOVE RETAINER PLATE
Remove the 4 screws and retainer plate from the generator drive end frame.
Using SST and a hammer, tap out the generator drive end frame bearing.