Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM (w/ Advanced Park) › from 2021.07
RM3700E _56 Audio / Visual / Telematics _093031 PARK ASSIST / MONITORING _0485736 PANORAMIC VIEW MONITOR SYSTEM(w/ Advanced Park) C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM(w/ Advanced Park)  C162287  Rear Camera Image Signal Missing Message  


DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and the rear television camera assembly are not normal.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C162287 Rear Camera Image Signal Missing Message Open or short in the rear television camera signal circuit
·

Harness or connector

·

Rear television camera assembly

·

Parking assist ECU


Circumference Monitoring Camera Control Module A

WIRING DIAGRAM

E431809E15
5.552,3.052 6.823,3.271 1.271,0.219 10 false Parking Assist ECU 5.542,2.896 5.958,3.073 0.417,0.177 10 false O123 5.521,0.573 5.875,0.771 0.354,0.198 10 false CB+ 5.521,1.083 5.885,1.281 0.365,0.198 10 false CV+ 5.51,1.573 5.885,1.771 0.375,0.198 10 false CV- 5.292,0.51 5.729,0.708 0.438,0.198 10 false 2 5.292,1.479 5.438,1.688 0.146,0.208 10 false 3 5.51,2.01 6.042,2.219 0.531,0.208 10 false CGND 5.292,1.938 5.729,2.135 0.438,0.198 10 false 1 5.302,2.302 5.479,2.479 0.177,0.177 10 false 5 5.521,2.396 5.99,2.583 0.469,0.188 10 false SGND 0.438,2.875 0.729,3.063 0.292,0.188 10 false Y35 0.427,3.052 2.573,3.302 2.146,0.25 10 false Rear Television Camera Assembly 1.292,0.594 1.667,0.781 0.375,0.188 10 false CB+ 1.292,1.094 1.646,1.271 0.354,0.177 10 false CV+ 1.313,1.573 1.635,1.771 0.323,0.198 10 false CV- 1.177,2.021 1.646,2.208 0.469,0.188 10 false CGND 1.719,0.979 1.927,1.146 0.208,0.167 10 false 4 1.708,0.5 1.906,0.688 0.198,0.188 10 false 2 1.708,1.917 2.146,2.115 0.438,0.198 10 false 1 1.719,2.302 1.875,2.49 0.156,0.188 10 false 5 3.521,2.365 3.677,2.563 0.156,0.198 10 false * 0.333,3.417 1.854,3.677 1.521,0.26 10 false *: Shielded 1.188,2.396 1.708,2.573 0.521,0.177 10 false SGND 1.719,1.479 1.927,1.667 0.208,0.188 10 false 3 5.302,0.979 5.74,1.177 0.438,0.198 10 false 4

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM (w/ Advanced Park)>CALIBRATION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY)

Pre-procedure1

a.

Disconnect the O123 parking assist ECU connector.


b.

Disconnect the Y35 rear television camera assembly connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(O123,Y35)Location & Routing

Click Connector(O123)Body>Floor Wire>Parking Assist ECU

Click Connector(Y35)Body>No. 2 Back Door Wire>Rear Television Camera Assembly

O123-2 (CB+) - Y35-2 (CB+) Always Below 1 Ω
O123-4 (CV+) - Y35-4 (CV+) Always Below 1 Ω
O123-3 (CV-) - Y35-3 (CV-) Always Below 1 Ω
O123-1 (CGND) - Y35-1 (CGND) Always Below 1 Ω
O123-5 (SGND) - Y35-5 (SGND) Always Below 1 Ω
O123-2 (CB+) or Y35-2 (CB+) - Body ground Always 10 kΩ or higher
O123-4 (CV+) or Y35-4 (CV+) - Body ground Always 10 kΩ or higher
O123-3 (CV-) or Y35-3 (CV-) - Body ground Always 10 kΩ or higher
O123-1 (CGND) or Y35-1 (CGND) - Body ground Always 10 kΩ or higher
O123-5 (SGND) or Y35-5 (SGND) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

2.CHECK PARKING ASSIST ECU (CV-, CGND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK PARKING ASSIST ECU (CV-, CGND)

Pre-procedure1

a.
E394295C09
0.188,0.927 0.698,1.24 0.51,0.313 2,0.854 2.563,0.531 true 1.99,1.094 2.573,1.552 true 0.073,0.063 0.385,0.26 0.313,0.198 10 false *a 2.646,0.417 3.167,0.615 0.521,0.198 10 false CGND 2.667,1.49 3.188,1.688 0.521,0.198 10 false CV- 0.271,0.99 0.885,1.188 0.615,0.198 10 false O123
*a Component without harness connected
(Parking Assist ECU)


Disconnect the O123 parking assist ECU connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(O123)Location & Routing

Click Connector(O123)Body>Floor Wire>Parking Assist ECU

O123-1 (CGND) - Body ground Always Below 1 Ω
O123-3 (CV-) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

3.CHECK PARKING ASSIST ECU (CB+, CGND)

NG

3.CHECK PARKING ASSIST ECU (CB+, CGND)

Pre-procedure1

a.

Disconnect the Y35 rear television camera assembly.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(Y35)Location & Routing

Click Connector(Y35)Body>No. 2 Back Door Wire>Rear Television Camera Assembly

Y35-1 (CGND) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(Y35)Location & Routing

Click Connector(Y35)Body>No. 2 Back Door Wire>Rear Television Camera Assembly

Y35-2 (CB+) - Y35-1 (CGND) Ignition switch ON 7 to 8 V
Y35-2 (CB+) - Y35-1 (CGND) Ignition switch off Below 1 V


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

NG