When the main body ECU (multiplex network body ECU) receives the light control switch position signal, it sends an illumination request signal to the light control LED ECU and illuminates the clearance lights.
HEADLIGHT ASSEMBLY CIRCUIT (for LED Headlight)
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*1
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CXPI communication malfunctions before troubleshooting this symptom.
*1: w/ Entry and Start System
Using the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Taillight / Clearance Light | Taillights and clearance lights | OFF or ON | - |
| Tester Display |
|---|
| Taillight / Clearance Light |
Clearance lights illuminate.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (LH side clearance light and daytime running light does not illuminate.) | B |
| NG (RH side clearance light and daytime running light does not illuminate.) | C |
A
B
C
Interchange the headlight lens sub-assembly LH with RH and connect the connectors.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>DISASSEMBLY
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the clearance lights.
The clearance lights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Interchange the light control LED ECU LH with RH and connect the connectors to them.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>DISASSEMBLY
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the clearance lights.
The clearance lights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Interchange the headlight lens sub-assembly RH with LH and connect the connectors.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>DISASSEMBLY
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the clearance lights.
The clearance lights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Interchange the light control LED ECU LH with RH and connect the connectors to them.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>DISASSEMBLY
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the clearance lights.
The clearance lights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG