Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR (for AWD) › from 2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0443009 REAR SPEED SENSOR(for AWD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for AWD)  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
C442423N02
0.271,4.833 1.313,5 1.042,0.167 0.229,4.792 1.354,5.042 1.125,0.25 1.427,4.344 1.76,4.344 false 3.646,4.583 3.979,4.583 false 6.49,0.25 6.823,0.25 false 0.75,4.49 0.75,4.823 false 2.104,4.188 2.385,4.542 0.281,0.354 18 false 1 3.438,4.438 3.719,4.792 0.281,0.354 18 false 2 6.271,0.115 6.552,0.469 0.281,0.354 18 false 3 0.354,4.844 1.438,4.99 1.083,0.146 8 false 8.5 (87, 75 in.*lbf)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR SKID CONTROL SENSOR 89544E (Click here) - -
2 REAR WHEEL - - - -
3 CHECK FOR SPEED SENSOR SIGNAL - (Click here) - -

V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89544E 1.INSTALL REAR SKID CONTROL SENSOR

Z101186

NOTICE:
·

Keep the tip of the rear skid control sensor and installation hole free of foreign matter.

·

Firmly insert the rear speed sensor body into the rear axle carrier sub-assembly before tightening the bolt.

·

After installing the rear speed sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear speed sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.




Torque:
: 8.5 N*m (87 kgf*cm, 75 in.*lbf)

Hide 2.INSTALL REAR WHEEL