The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front drive shaft oil seal removal/installation are shown below.
1.REMOVE FRONT DRIVE SHAFT ASSEMBLY
for TMMF Made:
Click hereDrivetrain>DRIVE SHAFT / PROPELLER SHAFT>FRONT DRIVE SHAFT ASSEMBLY (for M15A-FKS TMMF Made)>REMOVAL
43420H
2.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.
Do not damage the continuously variable transaxle assembly.
43410M
3.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the continuously variable transaxle assembly.
Do not damage the continuously variable transaxle assembly.
43420H
4.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *a | Drive in Depth |
Using SST and a hammer, install a new front drive shaft oil seal LH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Be sure to install the front drive shaft oil seal LH in the correct direction.
Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the front drive shaft oil seal LH.
43410M
5.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
| *a | Drive in Depth |
Using SST and a hammer, install a new front drive shaft oil seal RH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Be sure to install the front drive shaft oil seal RH in the correct direction.
Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the front drive shaft oil seal RH.
6.INSTALL FRONT DRIVE SHAFT ASSEMBLY