| *1 | REAR DISC BRAKE CYLINDER | - | - |
| ● | Non-reusable part | - | - |
If the rear disc brake cylinder assembly has been disassembled, perform air bleeding for the rear disc brake cylinder assembly.
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for AWD)>INSTALLATION
Make sure not to scratch, damage or apply excessive force to any of the internal components of the rear disc brake cylinder.
To prevent rusting on the inside of the rear disc brake cylinder, perform the rear disc brake piston removal and installation quickly.
Do not clean the interior of the rear disc brake cylinder with brake cleaner.
Do not remove any parts unless specifically instructed to do so, and only remove the parts indicated.
Make sure to enter pad replacement mode before removing the rear disc brake cylinder assembly.
for TMC Made: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMC Made)>UTILITY
for TMMF Made: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model TMMF Made)>TEST MODE PROCEDURE
1.REMOVE CYLINDER BOOT
|
|
Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the rear disc brake cylinder.
47831
2.REMOVE REAR DISC BRAKE PISTON
| *a | Cloth | - | - |
Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.
Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.
|
|
3.REMOVE PISTON SEAL
|
|
| *a | Nut | - | - |
Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the rear disc brake cylinder.
31478C
4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
47547C
5.REMOVE REAR DISC BRAKE BLEEDER PLUG