Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2011.08–2017.01
BM19S0E _V1 General _054878 INTRODUCTION _0267219 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

If only the installation area of the headlight is damaged, use a repair bracket for a low-cost repair.

·

Ensure that other areas of the headlight are not damaged.



INSTALL HEADLIGHT PROTECTOR UPPER RETAINER


a.
E222177

Cut off the portion indicated by the hatched lines in the illustration and smooth the surface with sandpaper.

NOTICE:

After cutting off the hatched lines, place the headlight protector upper retainer against the bosses and gradually file away the hatched lines until installation is possible.



b.
E222178

Install the headlight protector upper retainer with the 2 screws.



INSTALL HEADLIGHT PROTECTOR LOWER RETAINER


a.
E222179

Cut off the portion indicated by the hatched lines in the illustration and smooth the surface with sandpaper.

NOTICE:

After cutting off the hatched lines, place the headlight protector lower retainer against the bosses and gradually file away the hatched lines until installation is possible.



b.
E222180

Install the headlight protector lower retainer with the 3 screws.