Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2011.08–2017.01
BM19S0E _V1 General _054878 INTRODUCTION _0267219 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See Page
ECM ECU communication ID registration Engine start -
Throttle with motor body assembly, cleaning any throttle body components or Initialization (throttle position) Rough idle
Automatic transaxle assembly, engine assembly or ECM
·

Reset memory (AT initialization)

·

Road test


Large shift shock -
w/ VSC

Yaw rate sensor (Airbag sensor assembly)*1


Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


-
w/ VSC

Yaw rate deceleration sensor (Yaw rate sensor)*2


Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


-
w/ VSC

Brake actuator assembly (Skid control ECU)


Yaw rate and deceleration sensor zero point calibration


·

Warning light comes on

·

The deterioration of fuel efficiency


-
·

Power steering ECU assembly

·

Power steering motor assembly

·

Steering column assembly (containing the torque sensor)


·

Torque sensor zero point calibration

·

Assist map writing


·

Warning light comes on

·

Power assist stops


-
·

Door control receiver

·

Key


Registration of recognition codes Wireless door lock control system -
·

Transponder key ECU

·

Key

·

ECM


·

ECU communication ID registration

·

Key code registration


Engine start Refer to the Service Bulletin for the registration procedure.
Power window regulator motor Motor initialization
·

Jam protection function

·

Power window control system


-

*1: for Built-in Type Yaw Rate Sensor

*2: for Separate Type Yaw Rate Sensor