With the radiator side support removed.
REMOVAL
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut and Join Location |
After removing the *1, remove the member.
Carefully cut the member so not to damage *2.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| *a | 30 mm (1.18 in.) | *b | 310 mm (12.20 in.) |
| *c | 47 mm (1.85 in.) | *d | 232 mm (9.13 in.) |
| *e | 310 mm (12.20 in.) | - | - |
INSTALLATION
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Plug Weld |
|
Plug Weld |
|
Cut and Join Location |
|
Butt Weld |
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Divide a new part of front side member reinforcement in to *1 and *2 at the weld points. After welding the *2 to the vehicle side, install the *1.
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.