Home › Vehicle Exterior › BODY PANEL › REAR DOOR OUTER PANEL(for TMC Made)
BM19S0E _01 Vehicle Exterior _054879 BODY WELD POINT _0267238 REAR DOOR OUTER PANEL(for TMC Made) F

BODY WELD POINT  REAR DOOR OUTER PANEL(for TMC Made)  ASSEMBLY REPLACEMENT  


K101474

REMOVAL


Symbol meaning
K108828

Cut Location for Supply Parts


REMOVAL POINT
1.

After grinding off the hemming location, remove the outer panel.


K101815E03
3.979,7.771 4.229,8.01 4.229,8.01 4.458,8.01 false 3.729,6.458 4.969,6.813 1.24,0.354 10 false Hemming Location 4.51,7.927 5.344,8.271 0.833,0.344 10 false Disc Sander

INSTALLATION


Symbol meaning
K108831

Butt Weld
K108833

Spot MIG Weld
K108834

Body Sealer


INSTALLATION POINT
1.

Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

NOTICE:

Do not close the drain hole.


HINT:

Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.


2.

Bend the flange hem about 30° with a hammer and dolly. Then, fasten tightly with a hemming tool.

HINT:
·

Perform hemming in three steps, being careful not to warp the panel.

·

If a hemming tool cannot be used, hem with a hammer and dolly.



3.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K132633E01
1.958,4.323 1.958,3.979 false 5.417,5.969 5.552,5.563 5.552,5.563 5.677,5.563 false 5.813,6.167 6.052,5.917 6.052,5.917 6.177,5.917 false 5.979,6.698 6.146,6.979 6.146,6.979 6.271,6.979 false 5.583,8.719 5.75,9 5.75,9 5.875,9 false 1.115,4.344 3.073,5 1.958,0.656 10 false REAR DOOR PANEL OUTER 4.677,2.083 5.313,2.479 0.635,0.396 10 false 10 (0.39) 5.99,3.688 7.031,4.094 1.042,0.406 10 false Drain Hole 5.74,5.469 6.531,5.75 0.792,0.281 10 false Dolly 6.26,5.823 7.01,6.229 0.75,0.406 10 false Cloth Tape 6.313,6.896 7.063,7.302 0.75,0.406 10 false Hammer 5.927,8.927 6.969,9.333 1.042,0.406 10 false Hemming Tool 0.281,9.469 0.938,9.781 0.656,0.313 10 false mm (in.) 4.771,6.521 5.042,6.802 0.271,0.281 10 false 30°