Home › Vehicle Exterior › BODY PANEL › ROOF PANEL(for Glass Roof)
BM19S0E _01 Vehicle Exterior _054879 BODY WELD POINT _0267260 ROOF PANEL(for Glass Roof) F

BODY WELD POINT  ROOF PANEL(for Glass Roof)  ASSEMBLY REPLACEMENT  


K101520

REMOVAL


Symbol meaning
K108818

Remove Weld Points


U158800E02
6.638,1.472 6.749,1.624 0.111,0.152 10 2 5.405,0.753 5.516,0.905 0.111,0.152 10 8 5.405,4.536 5.516,4.688 0.111,0.152 10 8 6.638,3.77 6.749,3.922 0.111,0.152 10 2 3.696,6.957 3.807,7.109 0.111,0.152 10 3 3.575,8.858 3.685,9.010 0.111,0.152 10 3 2.557,8.858 2.667,9.010 0.111,0.152 10 4 4.724,8.858 4.834,9.010 0.111,0.152 10 7 4.761,6.957 4.872,7.109 0.111,0.152 10 1 2.706,6.957 2.817,7.109 0.111,0.152 10 1 5.77,7.415 5.880,7.567 0.111,0.152 10 4 1.548,7.415 1.658,7.567 0.111,0.152 10 4 4.179,2.642 4.378,2.794 0.199,0.152 10 11

INSTALLATION


Symbol meaning
K108821

Spot Weld
K108823

Plug Weld
K108834

Body Sealer


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After the roof panel reinforcement is welded to the new parts, install the roof panel rear to the vehicle side.

4.

Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement and back door opening frame.

HINT:

Apply just enough body sealer for the new parts to make contact.


5.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

6.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K101555

K132137E02
4.25,5.01 4.583,5.01 4.583,5.01 4.896,3.896 false 2.917,4.917 4.5,5.438 1.583,0.521 10 false ROOF PANEL REAR