Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
| Mark | Measurement (along surface) |
|---|---|
| *1 | 223.8 mm (8.81 in.) |
| *2 | 211.9 mm (8.34 in.) |
| *3 | 167.1 mm (6.58 in.) |
INSTALL NO. 6 BACK DOOR NAME PLATE
| Mark | Measurement (along surface) |
|---|---|
| *1 | 215.8 mm (8.50 in.) |
| *2 | 220.0 mm (8.66 in.) |
| *3 | 51.5 mm (2.03 in.) |
INSTALL SYMBOL EMBLEM
| *1 | Location Pin |