Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › from 2017.01
BM19S0E _V1 General _054878 INTRODUCTION _0267219 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed Note
ECM Vehicle Identification Number (VIN) registration DTC P0630 is output for Registration (1NZ-FE)
for Registration (2NZ-FE)
ECU communication ID registration Engine start Refer to the Service Bulletin for the registration procedure.
·

Throttle body with motor assembly or any throttle body components

·

Throttle body is cleaned

·

Engine assembly

·

Cylinder head

·

Camshaft (for intake side)

·

Camshaft timing gear assembly

·

Piston or piston ring

·

Mass air flow meter

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

No.1 ignition coil

·

Knock sensor

·

Air leaks from intake system

·

Gas leaks from exhaust system


Inspection after repairs - for Initialization (1NZ-FE)
for Initialization (2NZ-FE)
·

Pre-crash safety city sensor*4

·

Windshield glass*4


·

Recognition camera/target position memory

·

Recognition camera axis adjust


·

Lane departure alert system

·

Pre-crash safety system

·

Automatic high beam system


-
Automatic transaxle assembly, engine assembly or ECM
·

Reset memory (AT initialization)

·

Road test


Large shift shock for Initialization (U340E)
for Initialization (U441E)
Yaw rate sensor (Airbag sensor assembly)*1 Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


for Calibration (vehicle stability control system)
Yaw rate deceleration sensor (Yaw rate sensor)*2 Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


for Calibration (vehicle stability control system)
Brake actuator assembly (Skid control ECU) Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


for Calibration (vehicle stability control system)*1
for Calibration (vehicle stability control system)*2
·

Power steering ECU assembly

·

Power steering motor assembly

·

Steering column assembly (containing the torque sensor)


·

Torque sensor zero point calibration

·

Assist map writing


·

Warning light comes on

·

Power assist stops


for Calibration (power steering system)
·

Door control receiver

·

Key


Registration of recognition codes Wireless door lock control system for Registration (wireless door lock control system)
·

Transponder key ECU

·

Key

·

ECM


·

ECU communication ID registration

·

Key code registration


Engine start Refer to the Service Bulletin for the registration procedure.
Power window regulator motor Motor initialization
·

Jam protection function

·

Power window control system


for Initialization (Power window control system)
·

Headlight leveling ECU assembly*3

·

Rear height control sensor sub-assembly*3


Perform Headlight leveling ECU initialization Automatic headlight beam level control function for Initialization (Automatic headlight beam level control system)

*1: for Built-in Type Yaw Rate Sensor

*2: for Separate Type Yaw Rate Sensor

*3: w/ Automatic Headlight Beam Level Control System

*4: w/ Toyota Safety Sense